How to change Zigbee transmission cycle

It sets the information collection cycle of RN001 product. Modifications to this information will propagate to wireless sensors, wireless repeaters, etc., changing the default cycle of all devices. The default value is set to 10 minutes (minimum 1 minute to maximum 60 minutes can be set).

1. Product Preparation

1. RN001 (Gateway)
2. 6V DC Adapter
3. USB 2.0 AM / AM Cable
4. Radionode's Terminal Program Download
5. RN001 Data Sheet 

2. How to change the RN001 transmission cycle

1. To RN001 (Gateway) 6V DC AdapterTo supply power.
2. Front of RN001 'CLOUD CHK IN' In part LED If is on, after 30 seconds AdapterDisconnect and reconnect. 'CLOUD CHK IN' In part LED should not come on Communication with PC is possible.
3. USB cableUsing RN001(Gateway) and PCConnect.
4. On PC Radionode's Terminal ProgramRun and enter the password (radionode114).
5. '5. Select'RF Cordinator' and click '4. Select'Set Sensing Interval(10 Mins)'.
6. Enter the desired transmission cycle and press Enter.(Min 1 min ~ Max 60 min)
7. Reboot the product by disconnecting the 6V DC adapter and USB cable and reconnecting.
   • If only the transmission cycle is changed, only the adapter is reconnected.
   • When performing additional settings, reconnect both the adapter and USB cable.

3. Notice

1. The transmission cycle of RN001 changeIf you do, all the nodes you are using (RN200, RN300, RN500) All transmission cycles are changed.
2. When the transmission period is set to the minimum unit, 1 minute, the RN300 Battery consumption will increase.