Zigbee temperature sensor calibration method

1. Product Preparation

1. RN001 (Gateway)
2. 6V DC Adapter
3. USB 2.0 AM / AM Cable
4. Radionode's Terminal Program Download
5. RN001 Data Sheet 

2. How to check RN300 data

1. To RN001 (Gateway) 6V DC AdapterConnect.
2. From RN001 CLOUD CHK IN에 LED If comes in, after 30 seconds AdapterDisconnect and reconnect. CLOUD CHK IN LEDIt must not come in to communicate with the PC.
3. RN001 (Gateway) USB cable을 이용 하여 PCConnect to.
4. On PC Radionode's Terminal ProgramRun it.
5. radionode114 input → 5. RF Cordinator. → 1.View Remote Node List
6. RN300 powerAfter turning on 1. Check the data in the View Remote Node List.

3. Precautions

Network IDRN001 ↔ RN300 products must be the same.
Customers who request calibration RN001 Network ID It is not recommended to change the settings. If data is not received even if the RN300 is close to RN001 Network IDPlease check the data by receiving another RN001 from the customer who requested calibration.

When requesting calibration for multiple RN300 products, it is highly likely to use multiple RN001s.

The maximum number of units that can be attached to RN001 per one RN300 is eight, and if there are more than eight, RN8 is required. (Example: When RN8 is attached to RN200, 001 units can be attached to RN200, and 001 additional units can be attached to RN7.)

If the RN001 product is from 2015, it is difficult to use USB, so please proceed by checking the data in radionode365.