Copying RN400 settings (using SD card)

Thank you for purchasing the DEKIST RN400 product.

To copy the settings, all set values ​​such as AP (WiFi), measurement/transmission period, and server settings are copied. Save to SD cardTo other RN400 복사How to do it.

Micro SD card The method of copying is to use the ATCFG command, Micro SD card The main methods of saving and copying the settings of the already installed RN400 device are provided. It is recommended to use the former when installing multiple devices in the same environment, and the latter when adding devices in an environment where installation is complete.

준비물

Micro SD card (16GB or less, formatted with FAT32 file system)

1. Using the ATCFG command

1. Check – The file system of the prepared Micro SD card is FAT32 confirm that it is.
  FAT32 Only file systems are supported.

2. Insert – of the device powerTurn off and insert the prepared Micro SD card into the Micro SD card holder on the inner side of the cover. Please refer to the picture below.

3. Settings – After powering on the device, activate RN400 AP MODE in the settings window of your smartphone or laptop. SERVER SETUP, MEASUREMENT, WiFi SETUP Enter the appropriate settings.

4. Save – After confirming that the set value is entered correctly, OTHERS SETUP From the menu Debug Code DBG command in the command input window ATCFGAfter entering OTHER SETUP, select the Save button on the right.

5. Save Confirmation – Debug Code in the command input window SAVE CONFIG! is expressed. Please refer to the picture below.

• 

• 

6. Power OFF – Turn off the product. (Power On/Off) Press the button to turn it off.

7. Ejecting the card – Gently press the top of the Micro SD card where the setting information is stored in the downward direction and then take it out.

8. New device booting – with the system power off, the setup information is stored in the holder inside the lid.
After inserting the micro SD card, (S) + (W) + (Power On/Off) button simultaneously. Please refer to the picture below.

9. Screen Check – The following texts appear on the screen in order.

• SYSTEM CONFIG CHECKING..SDCARD
• NO IMAGE FILE! UPDATE CANCELED… .
• NEW CONFIG FILE IS LOADED.
• **SYSTEM-RESET** RN400 IS RE-BOOTING.

10. Copy complete – set value when device reboots properly 복사Is complete.

2. Installing settings on additional devices

1. Copy settings – supported Micro SD cardis inserted into the holder located inside the lid, and in the setting window of the smartphone or PC screen connected in AP mode. Display/Other Settingsto find back upof Save setting information to SD Card in the field to copy Select the button.

2. Eject – saved settings Micro SD cardGently press up and down, and then remove it.

3. Insert the new device card – stored in the holder located inside the lid of the new device. Micro SD cardis inserted.

4. Check System Down – located at the bottom of the screen on the front of the device. (P) buttonPress to run system down.

5. Boot – (S) button과 (W) buttonwhile simultaneously holding down (P) buttonPress to execute system boot.

6. Check the settings – ' on the screen on the front of the deviceNEW CONFIG FILE IS LOADED' is displayed, the copy was successful.